Bond It Mitre Bonding System Kit Activator 200ml & Superglue 50g Joint Wood Glue

Used in conjunction an almost instant bond is

attained. Ideal for fine joints such as mitres where a

close aesthetically pleasing joint is required.

Uses

Bond It MITRE KIT can be used for bonding

• MDF Chipboard
• Oak
• Pine
• All common timbers.
• PVCu
• Rubber
• Preparation

Surfaces to be bonded must be clean, dry and free

from dust, grease or contaminants that may hinder

adhesion.

Application

Spray aerosol lightly over one face of the joint and

allow to dry. If possible, use on the least visible face

of the completed joint. Apply adhesive to the other

face and bring together immediately. Apply gentle

pressure.

IMPORTANT: Can be used on uPVC but over

application of the accelerator can result in staining.

This stain may not become visible for several hours

after application. Apply to a test sample to check

application level to avoid any staining on final job.

Bonding Times

The speed of cure varies according to the substrate

to be bonded. Timber and metals will have a longer

cure time than plastics and rubbers. Best results are

achieved on close fitting parts with a very thin bond

line. Excessive bond gaps will result in slower cure

speeds.

Limitations

Not suitable for permanent glass bonding.

Oily or greasy surfaces cannot be bonded.

Olefinic or fluro polymers may require

specialised bonding techniques.

Storage Conditions

Store in a closed upright container between 5

and 25°C in dry dark conditions. At low

temperatures the shelf life will be prolonged.

Keep out of direct sunlight.