PRODUCT FEATURES
Properties
– Solvent and Moisture Free
– Quick Cure and Rapid Bond Strength
– Permanently Elastic
– Suitable for use with Underfloor Heating
Uses
For the internal bonding of parquet, mosaic, oak,
wood block, laminated, exotic timber and many other
wood floor types to porous or non porous substrates
including; screeds, chipboard, plywood, concrete
and anhydrite. WOOD PRO is also compatible with
substrates incorporating under-floor heating
systems.
Preparation
All surfaces must clean, dry and free from, grease,
polish, old adhesive remnants or any other
contaminates that may hinder adhesion. Loose,
friable or cracked areas should be repaired prior to
application. The moisture content throughout the
substrate should be checked by Hygrometer,
ensuring that the moisture content does not exceed
that recommended by the wood flooring
manufacturer for the particular substrate. In
particular Anhydrite levels would differ to those of
concrete. The wood flooring should also be checked
that the relative humidity figure falls within those
recommended by the manufacturer. Note; underfloor
heating systems should be turned off 48 hours
before and 48 hours after application. All wood
flooring should be acclimatised for several days in
the room where it is to be installed.
Application
The application temperature should not be below
+10o
C and not above +30o
C, materials should be
acclimatised to this temperature in the intended
application site prior to installation. Solid floors
should have an existing DPM in place.
Use the notched nozzle provided for maximum
transfer. Apply the adhesive to the substrate in a
triangular bead 8mm wide by 10mm high and at
250mmcentres at right angles to the length of the
wood. Do not apply more adhesive than will be used
within 20 minutes of application. To ensure
maximum transfer of adhesive to the wood, lay into
the adhesive with a slight twisting motion and tap
into place.
WOOD PRO will take at least 24 hours to cure
assuming a temperature of 23OC at 50% RH. Cooler
and / or less humid conditions will extend drying
times. Wait until the adhesive has fully cured before
sanding or finishing the flooring.
