PRODUCT FEATURES
Used in conjunction an almost instant bond is
attained. Ideal for fine joints such as mitres where a
close aesthetically pleasing joint is required.
Uses
Bond It MITRE KIT can be used for bonding
- MDF Chipboard
- Oak
- Pine
- All common timbers.
- PVCu
- Rubber
- Preparation
Surfaces to be bonded must be clean, dry and free
from dust, grease or contaminants that may hinder
adhesion.
Application
Spray aerosol lightly over one face of the joint and
allow to dry. If possible, use on the least visible face
of the completed joint. Apply adhesive to the other
face and bring together immediately. Apply gentle
pressure.
IMPORTANT: Can be used on uPVC but over
application of the accelerator can result in staining.
This stain may not become visible for several hours
after application. Apply to a test sample to check
application level to avoid any staining on final job.
Bonding Times
The speed of cure varies according to the substrate
to be bonded. Timber and metals will have a longer
cure time than plastics and rubbers. Best results are
achieved on close fitting parts with a very thin bond
line. Excessive bond gaps will result in slower cure
speeds.
Limitations
Not suitable for permanent glass bonding.
Oily or greasy surfaces cannot be bonded.
Olefinic or fluro polymers may require
specialised bonding techniques.
Storage Conditions
Store in a closed upright container between 5
and 25°C in dry dark conditions. At low
temperatures the shelf life will be prolonged.
Keep out of direct sunlight.
